The 1/2-inch soffit panel system is mechanically attached and installed in a sequential pattern. All panel systems are to be roll formed to specified dimensions and tolerances and shall be accurately formed.
The 1/2-inch soffit panel system is mechanically attached and installed in a sequential pattern. All panel systems are to be roll formed to specified dimensions and tolerances and shall be accurately formed.
· 35-year warranty on coil-coated Kynar 500®/Hylar 5000®
· Male/female interlocking joint design
· Optional vented profile
· Sequential installation
· Lightweight
· Coil anodized aluminum
· Coil-coated aluminum (20-year warranty)
· Panel width 12″
· Post-painted aluminum skins (short run, custom colors) 0.063 to 0.125
· Batch anodized
· Coil-anodized
· Custom coatings
· Kynar 500®/Hylar 5000® high performance fluorocarbon resinous coatings
· Length restrictions apply
· Oil canning is not a cause for rejection
· Panel edges must be straight lines (no curves)
· Panels cannot be radiused
· Panels cannot be tapered
· Panels may exhibit out of plane behavior
· Panels may not be curved
• 35-year warranty on coil-coated Kynar 500®/Hylar 5000®
• Male/female interlocking joint design
• Optional vented profile
• Sequential installation
• Very lightweight
Your response helps us make our online experience better to provide content that is specific to your role.
Thank you. Your response helps us make our online experience better to provide content that is specific to your role.