Your response helps us make our online experience better to provide content that is specific to your role.
Thank you. Your response helps us make our online experience better to provide content that is specific to your role.
Only a few accessories are needed to install the RubberCover EPDM system properly. These are available from Elevate and are very easy to use.
Discover our range of accessories:
EPDM seaming products that facilitate the installation of the RubberCover EPDM membrane.
Designed to clean and prime the RubberCover EPDM membrane and/or substrate that are to receive a QuickSeam product.
Semi-cured EPDM strip laminated to a QuickSeam tape. It is used to cover and seal butt-joined RubberCover EPDM membranes.
Round piece of uncured EPDM FormFlash laminated to QuickSeam tape. It is designed to flash outside corners or to be used as a cover patch where appropriate.
Pre-fabricated pipe boot with a QuickSeam tape laminated to the bottom of its flange. Specifically designed for flashing rigid round penetrations and conduits of 25 mm to 152 mm.
Non-reinforced 1.5 mm thick RubberCover EPDM membrane, fully laminated to QuickSeam tape. It is used to easily flash details where cured EPDM is required or preferred: curbs, parapets, gutters, general roof repairs, drain and pipe flanges.
All you need for bonding and cleaning RubberCover EPDM membranes.
Solvent-based contact adhesive designed specifically for bonding RubberCover EPDM membranes to approved insulations in addition to wood, metal, masonry and other acceptable substrates.
Sprayable solvent-based contact adhesive specifically designed for bonding RubberCover EPDM membranes to approved insulations in addition to wood, metal, masonry and other acceptable substrates.
Alcohol-based degreaser with extremely fast evaporation properties, designed for efficiently removing all types of Elevate adhesives, sealants and other types of contamination from EPDM membranes, metal and many other solvent-resistant surfaces.
We provide you with the right professional tools for a quality installation of the RubberCover EPDM roofing system.
Professional spray gun with extension, to be used in combination with the 4 m rubber hose. Both products are specifically designed to spray Elevate adhesives.
Used for the application of the QuickPrime Plus primer.
Used for rolling seams and installation details after the application of QuickSeam products.